8
c.
Swivel mount:
This mount allows
you to adjust the angle of your
SKYFi2 Vehicle Adaptor after it
is installed. This mount uses a
strong adhesive that is not eas-
ily repositioned when installed,
so use care when choosing the
location of and placing the
mount. Do not install this mount
on a leather surface. Install the
mount only if the temperature
is at least 60°F.
– Clean the mounting surface
with the enclosed surface
preparation cleaning kit.
Wipe the towelette in one
direction only. Do not wipe
the surface in a circular
adhesive pad and adhere to
the vehicle’s surface. Make
sure you accurately place the
pad on the first try since in
many cases it will bond
almost immediately. For best
results, do not touch or apply
pressure to the vehicle mount
for 72 hours.
motion or back and forth. Dry
the area with a clean, dry
cloth. Repeat the cleaning
process. Allow to air dry
thoroughly.
– Clean the same surface with
the enclosed alcohol prep
pad. Wipe in one direction
only. Dry the area with a
clean, dry cloth. Allow to air
dry thoroughly.
– Warm the vehicle mount
adhesive pad by using a hair
dryer or by placing the vehicle
mount on top of the vehicle’s
defrost outlet for several
minutes with the heater on.
Remove the liner from the
