10
The appliance is not to be used if it has
been dropped, if there are visible signs of
damage or if it is leaking.
If the ironing system
is dropped causing visible damage to the appliance (steam
generator or iron), do not use. Take to customer services.
Designated use
• This appliance must be used exclusively for the purpose
for which it was expressly conceived. Any other use is
considered improper and thus dangerous.
• The manufacturer is not liable for damage caused by
inappropriate, incorrect or irresponsible use or for da-
mage resulting from repairs carried out by unqualified
personnel.
Description of the appliance
(see page 3)
A
Water reservoir door
B
Water reservoir filter
C
Reservoir release lever
D
Removable water reservoir
E
Regenerable limescale filter
F
Limescale filter retainer lever
G
Hook for steam/cable tube and protective cap for lime-
scale prevention system
H
Iron rest
I
Cable tidy
Accessories
J
Indicator paper to measure water hardness
Control panel
K
“Safe Transport” lock/release
L
“No water” light
M
“
OK
”: button, confirms filling of the reservoir (
if held
down for at least 5 seconds
, confirms filter regeneration
or steam generator cleaning)
N
Filter replacement light
O
Water hardness regulator
P
ON/OFF and steam regulation dial with
Iron
Q
Iron on light
R
Steam button
S
Thermostat dial
Preparations for use
What water to use
The appliance works with
normal tap water.
Important!
Never use chemical substances or detergents (e.g. perfumed
water, essences, descaling solution, etc).
Do not use mineral or other types of water (such as rainwater
or water for batteries or air conditioners etc.).
Setting water hardness
This ironing system has a resin limescale filter installed in the
water reservoir, allowing you to use ordinary tap water.
The resins reduce water hardness, prolonging the working life
of the appliance.
The filter must be replaced when the
light on the ap-
pliance control panel comes on. To customise the warning
according to the water used, proceed as follows:
• check the hardness of your water using the indicator
paper
J
provided:
• dip the paper in the water for 1 second,
• shake to remove excess water;
• wait for 1 minute;
• check the result in the table and use a coin to turn the
water hardness regulator
Q
to the position correspon-
ding to your water hardness:
0 - 9 °F
10 - 18 °F
19 - 36 °F
36 °F
⋀
Filling the reservoir
Danger!
Make sure the power cable is unplugged from the mains so-
cket.
Description
en