4
ELECTRICAL CONNECTION
Before connecting the plug to the power
outlet, make sure that the voltage of your
electrical system corresponds to the vol-
tage shown on the appliance rating label
and the outlet you are going to use is in
good condition.
INSTALLATION
The appliance may be used on any rigid
horizontal surface. Do not overload the
electrical circuit; avoid using the same
outlet for multiple appliances.
OPERATION AND USE
1. Connect the appliance to the power
outlet.
2. The appliance emits a beep and the
power indicator light (H) comes on
and remains on as long as the
appliance is powered.
3. The appliance goes into OFF.
If the display shows a blinking dot, it
means that the tip over switch has
been activated. See paragraph:
“Additional safety features” page 6.
4. Press the ON/OFF button (A) to turn
on the appliance. It will begin to heat
with the predefined settings.
5. Press the MODE button (F) to select
one of the following functions availa-
ble:
Ventilation ( ) Anti-freeze ( )
Heating at minimum power
( 1 )
Heating at maximum power/BOOST
function (2)
5.1 Ventilation ( )
In this operating mode only the
fan operates, so the appliance
does not heat the room.
5.2 Anti-freeze ( )
In this operating mode the
appliance keeps the room at a
temperature of 45°F (7°C) to pre-
vent freezing temperatures.
5.3 Heating 1 and Heating 2
In this operating mode you can set
the desired temperature by pres-
sing the + and - adjustment but-
tons (B).
Heating 1 (minimum power
level):
The appliance operates at the
minimum power, reducing noise
and energy consumption to the
minimum.
Heating 2/BOOST function (maxi-
mum power level):
The appliance operates at the
maximum power for rapid heating
extension cord or outlet strip. Connect
the appliance directly to a suitable
outlet.
20. Make sure that the plug is fully inserted
into the outlet. Wall outlets may deterio-
rate with time, so check the plug perio-
dically for signs of overheating or defor-
mation. If the outlet has deteriorated,
stop using it and have it repaired.
21.Check that neither the appliance nor
the power cord have been damaged
during shipping.
22.Make sure that no styrofoam or other
packing materials remain in the appliance.
23.The first time the appliance is used, run
it at the maximum power for at least
two hours. During this time, ventilate
the room thoroughly to eliminate the
“new” smell released by the appliance.
It is completely normal for the applian-
ce to emit “creaking” sounds the first
time it is run.
24. CAUTION: To prevent electric shock,
make sure the wide prong of the plug is
inserted in the wide slot of the outlet.
25.Do not place the heater near a bed
because objects such as pillows or
blankets can fall off the bed and be
ignited by the heater.
26.Extreme caution is necessary whenever
the heater is left operating unattended.
27.Do not open the appliance. No user-
serviceable parts inside.
SAVE THESE INSTRUCTIONS
For Household use only
