7
Changing of the temperature scale
The display can show the temperature in both °F (Fahrenheit)
and °C (Celsius). To select the desired temperature scale,
when the unit is in standby position, press and hold the "+"
key for at least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
MAINTENANCE
Before carrying out any maintenance, unplug the heater from
the outlet and wait for it to cool off completely. This heater
requires no particular maintenance. It is sufficient to remove
the dust with a soft, dry cloth. Never use abrasive powders or
solvents. If necessary remove concentrated areas of dirt with
a vacuum cleaner.
TECHNICAL CHARACTERISTICS
Power supply
See rating label
Absorbed power
“
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The appliance doesn't work
The appliance doesn't work
(the display could blink
and you could hear an
intermittent "beep")
The display shows a
blinking dot and you hear an
intermittend "beep"
The display shows "
PF
"
The display shows "
H
t
"
blincking (the heating
power will progressively and
automatically be reduced)
Be sure it is plugged in and that the electrical
outlet is working
The temperature may be set too low
The Key lock may be activated
The air intake or outlet grille is obstructed
The appliance could be tipped over or is
positioned in an improper way
The temperature sensor is malfunctioning
The internal temperature is too high
Plug into the power outlet
Set the temperature to a higher position
See the section "Key lock"
Remove the obstruction remove the plug
from the outlet and let the appliance cool
down. After few minutes plug the appliance
again. If the appliance doesn't work please
contact the De longhi toll free number.
Make sure the appliance is standing
upright on a flat surface. Position the
appliance correctly
Contact the De longhi toll free number.
To remove the cause of this alarm check
that the unit is not covered or obstructed.
The appliance will operate again after few
minutes.
Check the appliance is correctly positioned
respecting the minum distances from the
wall, or objects, as indicated on the rating
label, if not, position the appliance correctly.
The appliance will operate again after few
minutes.
