3
1) Place the gas cylinder in the gas cylinder
compartment and connect the regulator to
the cylinder as shown on page 4.
2) To fit the backcover, insert the two tabs
located on the left-hand side of the back-
cover into the corresponding slots in the
cabinet. Then insert the tab on the right
hand side into its slot.
IMPORTANT:
to remove the backcover,
lift the backcover and pull clear of the
slots.
ASSEMBLY
GENERAL SAFETY INSTRUCTIONS
Gas bottle
Gas Bottle with 9 kg of maximum capacity can be installed. Changing of gas bottle must not
be carried out in the presence of a naked flame. Use the gas bottle always in upright posi-
tion.MAKE SURE the black neoprene “O -Ring Seal is in place or the regulator bullnose.
Regularly examine, and if unduly compressed or damaged, replace. Support regulator with
one hand while aligning the regulator bullnose (threaded part) with the threaded gas outlet
on cylinder valve. Screw regulator handwheel ANTICLOCKWISE (LEFT HAND THREAD)
into gas outlet. Tighten regulator handwheel as ttight as possible by hand only. DO NOT
USE TOOLS OR LEVERS TO TIGHTEN. When connecting the regulator to the gas cylinder,
avoid undue twisting of the flexible hose. To place the bottle in position, remove the rear
panel; than put the bottle in position and replace the panel.
PLACE teh cylinder in the heater cabinet so that the cylinder valve is facing into the compart-
ment. Take care to ensure that is positioned in such a way that the flexible hose does not
come into contact with the metal panels of the heater, and avoid twisting of the flexible
hose.
OPEN cylinder valve by turning handwheel ANTICLOCKWISE. Now refer to the lighting
instruction on the heater itself. Please read carefully and follow the instructions. Do not turn
the bottle upside down to use completely its content.
5723001300 17-12-2003 9:40 Pagina 3
