See Rating
label
Type
Category
Execution
Max.input Med.input Low input
Gas
Pressure
Two burner
models
Three burner
models
Kw
g/h
3.5
254
Kw
g/h
4.2
305
Kw
g/h
2.85
207
Kw
g/h
1.8
131
Kw
g/h
1.50
109
28-30 mbar
7 m
3
/h
8.4 m
3
/h
Gas
combustion air
quantity
this appliance is designed to operate with butane, at nominal pressure: 28÷30 mbar
GENERAL SAFETY INSTRUCTIONS
CYLINDER VALVE
If heater does not competely extinguish, including pilot, when gas is turned off at the regulator, do not remove regulator. Return valve
to open position and leave heater alight, which is perfectly safe, until attended to by the gas supplier.
Regulators, Hoses and clips
Check that tubing is completely over the nozzles at each end of the tubing and that is held firmly in place by tube clips. Examine
flexible tubing regularly and get your Dealer to fit new tubing 400 mm long if perished, worn or damaged.
L.P.G. ATTACKS NATURAL RUBBER-USE ONLY TUBING TO B.S. 3212 TYPE 2 SUPPLIED BY YOUR
DEALER.
Avoid bending or constricting the rubber tube when the pressure regulator is connected to the gas
cylinder.
A REGULATOR B.S. 3016 SET AT 28 MBAR (11.2 IN W.G.) for butane must de connected to the
appliance with the above tubing, using suitable tube clips.
VENTILATION
USE ONLY IN A WELL VENTILATED ROOM
Adequate ventilation must be provided in rooms in which the heater is used. This ensures removal of the products combustion and
allows the entry of replacement air.
Adequate ventilation should considerably reduce the possibility of condensation accurring.
The following table shows the smallest size of room suitable for each heat setting and the ventilation which must be provided.
The heater may be used for short periods in smaller rooms.
MAINTENANCE
Ensure that the heater is kept free of dust. When the heater is not in use it should be covered and stored in a dust-free place. Stains
on the exterior should be removed with soapy solution when the heater is cold. Dry with a polishing cloth. DO NOT use abrasive
cleaners which will damage the paint finishes.
Refer any mayor maintenance to your Local Authorised Dealer Major servicing should be carried out annually. If in doubt refer to your
authorised dealer.
SAFETY GUARD
The guard on this appliance conforms to the requirements of B.S. 1945: 1971 and satisfies the heater appliance (fireguards)
regulations. The guard is to prevent risk of fire or injury from burns and no part of it should be permanently removed. It does not give
full protection for young children or the infirm.
87.5 cm
2
105 cm
2
18 m
3
MIN
MED
MAX
TWO BURNER MODELS
THREE BURNER MODELS
Room
Size
Room
Aperture
Room
Size
Room
Aperture
35 m
3
15 m
3
28.5 m
3
42 m
3
Heating Setting
4
