26
Min. air-cooling warning light
NB. For technical reasons, the temperature is not expressed in degrees but by a line increasing in thickness.
We therefore recommend that when starting up the appliance, the thermostat be turned to maximum
(thick green line = maximum cold). When the desired temperature has been reached, move the cursor
slowly away from the maximum cold position until the appliance is switched off by operation of the
thermostat. In this way the appliance has been programmed with the exact temperature degree required,
which is then maintained automatically by the thermostat.
This appliance is fitted with a safety device that blocks its operation if at least 3 minutes have not
elapsed from when it was last switched off.
SETTING THE TIMER
The programmer/timer, like all clocks, must be set to the
exact time. If for example it is 4.00 pm. (16.00), turn the
dial in a clockwise direction (following the direction of the
arrow) until the number 16 is lined up with the triangular
pointer (the arrows indicates 4:00 P.M. approximately ).
N.B.: Never turn the dial in an anti-clockwise direction!
The timer is in effect, an electric clock and works only if the
plug is connected to the power supply. Whenever the
plug is disconnected or there is a power failure, the
programmer stops (the clock is then “slow”) and must be
re-set.
The unit can be used in either programmed or non-
programmed mode.
PROGRAMMED MODE
1) Select the desired function as shown in the chart
overleaf.
2) Press the TIMER key, the “TIMER ON” signal light will
come ON.
3) Make sure that the timer indicates the correct time (see
instructions on setting).
4) Set the operating times by pushing out the notches on
the dial corresponding to the period required (each
notch represents 15 mins.)
The unit will now switch on and off each day at the
selected times.
N.B.: To override the programmed operating times, simply
press the ON/OFF key (the timer signal lamp ON will go
out)
NON-PROGRAMMED MODE
1) Press the TIMER ON key again, the TIMER ON signal lamp
will go out).
2) Select the desired function as shown in the chart on pg. 27.
21
20
19
16
CONTROL PANEL
THERMOSTAT
TIMER ON
MEMO CONTROL
Timer
ON/OFF Timer key
ON timer signal lamp
Thermostat
cursor
Air-cooling signal
lamp
Button ON/OFF
Plot lamp mains (continuous light)
or malfunction (flashing light)
Signal lamp indicating 3 min.wait (flashing)
or air-cooling (on continuously)
Automatic position
key
Min. speed warning light
Auto ventilation warning light
Auto min.
air-cooling
warning light
Max. air-cooling
warning light
Auto max. air-
cooling warning
light
Air-cooling key
Ventilation key
Max. speed warning light
21
20
19
16
Funzionamento
Operating time
