11
ENGLISH
O p e r a t i o n
SWITCHING THE APPLIANCE ON
Connect the appliance to the mains supply.
On the display two lines will appear indicating Stand-by mode
Press the ON/OFF button (
A
) and then the MODE button until the
relevant function indicator appears viz.:
Indicator C
: air-conditioning
Indicator D
: dehumidifying
Indicator E
: ventilation
AIR-CONDITIONING FUNCTION
This function is ideal in hot, humid weather conditions when the
atmosphere requires to be cooled and dehumidified.
To ensure proper function of the appliance, after selecting the air-
conditioning function, press b (
F
) or – (
G
) until the desired
temperature appears on the display.
The temperatures most suited to the atmosphere in summer vary
between (24-27°C) 75°-80°F. We do not advise selection of tem-
peratures much lower than those outside.
Select fan speed by pressing the “FAN” button (
Q
) until the fan
speed indicator appears:
MAX (
P
): if you want the maximum power of the air-conditioner to
reach the desired temperature as quickly as possible.
MIN (
O
): if you want to reduce the level of noise and still maintain
a good level of comfort.
SILENT (
N
):when minimum noise is required,
AUTO (
M
):if you prefer the appliance to select the fan speed for
the temperature selected on the display panel.
DEHUMIDIFYING FUNCTION
This function is ideal for reducing humidity in the atmosphere while
avoiding increases or decreases in temperature (in between sea-
sons, damp places, wet spells of weather).
When you select the dehumidifying function, the letters “ ” will
appear on the display.
The water is collected in the tank at the rear of the appliance.
When the tank is full, the appliance will stop working and the
display will show the letters “ ” (Full Tank); the tank must then be
emptied. When it is re-inserted, the appliance will re-start auto-
matically. N.B. remove the air exhaust hose (14).
In the air-conditioning function, the unit employs an exclusive con-
densation recycling system to dispose of excess moisture. In normal
conditions, condensation is disposed of automatically. When the
humidity is particularly high, an excess of condensation may built up
in the TANK
. When this happens, the display will show the letters
“ “ (Full Tank); indicating that the TANK should be emptied. Whe-
never conditions of high humidity make the problem recurrent, you
may discharge the excess water directly into a drain, using the rub-
ber tube supplied. The tube should be inserted into the hole provi-
ded, after having removed the rubber stopper. (see figure).
Make sure the TANK is put back correctly otherwise the display will
continue to show the letters “ ”
9
77
pac160 GB 25-01-2003 10:19 Pagina 11
