15
USING THE REMOTE CONTROL
• Point the remote control at the receiver (A11) on the air
conditioner. The remote control must be no more than 7
metres away from the appliance (fig. 10) (without obsta-
cles between the remote control and the receiver).
• The remote control must be handled with care. Do not drop
it or expose it to direct sunlight or sources of heat.
Please note:
The remote control can be safely stored in the ap-
propriate compartment (A12).
DESCRIPTION OF THE REMOTE CONTROL
D1.
ON/STAND-BY button
D2.
MODE button
D3.
Decrease button
D4.
Increase button
D5.
Air flow
D6.
Swing button
D7.
Silent button
D8.
Timer
button
D9.
ECO REAL FEEL button
D1
D9
D3
D5
D8
D6
D7
D2
D4
TURNING THE APPLIANCE ON/OFF
• Plug into the outlet.
• Press the
C1
C2
C4
C11
C13
C12
C9
C7
C5
C6
C3
C16
C14
C10
C15
C17
C8
button
(D1) (when turned on, the air condi-
tioner starts operating in the same mode as when it was
turned off) .
• To switch the appliance off, press the
C1
C2
C4
C11
C13
C12
C9
C7
C5
C6
C3
C16
C14
C10
C15
C17
C8
button (D1) .
Please note:
Never switch the appliance off by removing the
plug.
Always switch it off by pushing the
C1
C2
C4
C11
C13
C12
C9
C7
C5
C6
C3
C16
C14
C10
C15
C17
C8
button and waiting few
minutes before removing the plug. Only in this way the appli-
ance will perform the standard checkings.
SELECTING THE OPERATING MODES
To select the desired operating mode, touch repeatedly the
MODE button (D6) until the desired function is selected.
Most of the commands available on the remote control corre-
spond to those on the appliance control panel (C).
SELECTING THE TEMPERATURES
In conditioning mode press (D3) and (D4) buttons
to de-
crease/increase the desired temperature.
SELECTING THE AIR FLOW
In conditioning and fan modes, press (D5) button to increase/
decrease the desired air flow.
SWING FUNCTION
The SWING button (D6) moves the flap, evenly distributing the
air into the room.
When the SWING button is pressed, the flap will begin to move
forwards and backwards alternatively.
If pressed again, the flap will be locked into its current position.
When the button is next pressed, the flap will start to move
forwards and backwards again.
Notes: in order to avoid damaging the internal mechanisms, the
flap must not be moved manually.
SILENT FUNCTION
(available in conditioning
mode only)
By activating this function, the operating noise is further re-
duced. To activate it, press
(D7) button on the remote con-
trol. The display shows the relative symbol (C12).
SETTING THE TIMER
