13
TECHNICAL SPECIFICATIONS
Power supply voltage
see rating label
Max. absorbed power
during air conditioning “
Refrigerant “
Cooling capacity
“
LIMIT CONDITIONS
Room temperature for
air conditioning
64 ÷ 104°F 18 ÷ 40°C
Transport, filling, cleaning, recovery and disposal of
refrigerant should be performed by a technical service
centre appointed by the manufacturer only.
The appliance should be disposed of by a specialist centre
appointed by the manufacturer only.
TO AVOID DAMAGE TO THE UNIT:
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit
has been on its side, oil needs to return to the compressor to en-
sure proper function. Without allowing the unit this time (6-24
hours) the unit may function for only a short time, and then the
compressor will break down from lack of oil.
ELECTRICAL CONNECTION
This appliance is equipped with a 3 prong grounded plug. The
plug must be connected into an outlet that is properly installed
and grounded in the accordance with all local codes and ordi-
nances. Do not modify the plug provided with the appliance.
If it will not fit the outlet, have a proper outlet installed by a
qualified electrician or relocate the unit to a proper outlet. If the
household electrical supply does not meet the above specifica-
tions, or if you are not sure your home has an effective electrical
ground, have a qualified electrician or your local electrical utility
company check it and correct any problems.
SAFETY PLUG
The appliance is fitted with a safety plug to protect the power
cable.
If power is cut off, unplug from the outlet and make sure the
power cable is undamaged.
If the cable is damaged, call the service center immediately.
If power cuts off frequently and the power cable is undamaged,
contact a qualified electrician.
OPERATION OF THE SAFETY PLUG
If the safety device incorporated in the plug trips and cuts off
the power supply, check that the power cable and plug are not
damaged.
If the power cable is undamaged, to restore operation press the
"RESET" button.
To verify correct operation of the plug, press the "TEST" button
periodically and make sure the appliance disconnects. If this is
not the case, contact the service center.
To restore operation, press the "RESET" button.
