DeLonghi HMH, Инструкция по эксплуатации, Страница: 3 / 7

Thank you for choosing this De’Longhi heater. To get the
very best out of your new heater it is advisable to read
these instructions before using it. This will ensure that you
gain optimum results and use the appliance safely.
Electrical connection
- Before plugging the appliance into the mains, check that your
supply voltage is the same as that shown on the rating plate of
the appliance.
- If using more than one appliance at a time, it is important to
ensure that the ring main is adequate to cope with the power
requirements.
- It is important to ensure that the socket is adequately earthed.
- This appliance complies with EEC directive 89/336 regarding
electromagnetic compatibility.
Installation (If required)
Models with a motorised base can be wall-mounted, using 3 screws
and 3 wall plugs.
To wall-mount, proceed as follows:
Drill holes in the wall, as shown in Fig.1, paying particular attention
to the minimum distances indicated.
Hang the appliance on the wall and fasten it using the third screw
at the bottom.
The appliance must not be positioned directly underneath a fixed
power point.
Operation and use
Insert the plug into the mains socket and switch on.
Turn the thermostat clockwise to its highest setting (so the number
6 is at the pointer).
Select the heat setting as follows:
Minimum Power: Turn the function selector, so the number
1
is
positioned at the pointer (the pilot light will
come on).
Maximum Power: Turn the function selector, so the number 2 is
positioned at the pointer.
To turn the heater off, turn the function selector so the 0 is posi-
tioned at the pointer.
Adjusting the thermostat
When the room has reached the desired temperature, turn the
thermostat dial slowly in an anti-clockwise direction until you hear
a click and the red pilot light goes off. The thermostat will now
keep the temperature in the room constant, turning the heater on
and off as appropriate.
HMH
3
14 cm
(Min)
39 cm
Fig.1