4. USE OF THERMOSTAT
The thermostat operates according to room air temperature, rather than radiator temperatu-
re. Turning it counter-clockwise to smaller numbers would decrease the temperature; clockwi-
se to greater numbers would increase the temperature.
Antifreeze function
Turn the thermostat dial to the position and push the switches on. The appliance will
maintain a minimum room temperature of approximately 42°F (5°C), thus preventing free-
zing while conserving energy.
REMINDER
To completely shut the heater off, MIN/MED switches must be set in the “0” position.
Your product is equipped with a polarized alternating current line plug (a plug having one
blade wider than the other). There is only one way it can be plugged into a power supply.
This is a safety feature. If you are unable to insert the plug fully into the outlet, try again by
turning it the other way. If it would still not go in, it is probably due to an obsolete outlet
which should be replaced. Do not tamper with the plug or outlet to defeat the purpose of
this safety mechanism.
A safety device
A
safety device
switches the heater off in the event of overheating. To restart the heater, call
the nearest Service center.
5. MAINTENANCE AND SERVICE
Always unplug the heater from the power outlet and allow the radiator to cool. Wipe
radiator with a soft damp cloth; do not use detergents and abrasives. Should the radia-
tor not be in use over a certain length of time, roll the cable around the holder and store
it in a dry place. This appliance has been built to last for many years of trouble-free ser-
vice. In case of malfunction or doubt, do not try to repair the heater by yourself: this
might increase the risk of fire and electric shock. Call nearest Service Center Visit
www.delonghi.com for a completelist of Service Centers (U.S. Only).
TROUBLESHOOTING
4
PROBLEM
CAUSE
SOLUTION
The appliance doesn’t work • Be sure it is plugged in and
that the electrical outlet is
working.
• Check for any obstruction.
• The switches are in the OFF
position.
• The thermostat may be set too
low.
• Plug into the mains.
• Remove the obstruction. Let
the appliance cool down then
reinsert the plug into the
mains. If the appliance doe-
sn’t work please contact the
nearest service center.
• Switch on the appliance.
• Turn the thermostat to a
higher setting until the hea-
ter restarts.