DeLonghi ETAM29.62 SERIES, Инструкция по эксплуатации

Страница: 18 / 22

18
Setting water hardness
1. Press the icon (B2) to enter the menu.
2. Press or (fig. 7) and select “Water hardness”.
3. Confirm the selection by pressing the
OK
icon (fig. 4).
4. Press or repeatedly to set the level as meas-
ured by the indicator paper (see previous section).
5. Press the OK icon to confirm the setting.
6. Press the icon to exit the menu.
The machine is now reprogrammed with the new water
hardness setting.
WATER SOFTENER FILTER (*CERTAIN MODELS
ONLY)
Certain models are fitted with a water softener filter (C4). If this
is not the case with your model, you are recommended to pur-
chase one from De’Longhi Customer Services.
To use the filter correctly, follow the instructions below.
Installing the filter
33
1. Remove the filter (C4) from
the packaging.
2. Turn the date indicator
disk (see fig. 33) until the
next two months of use are
displayed.
Please note
The filter lasts about two
months if the appliance is used
normally. If the coffee machine
is left unused with the filter installed, it will last a maximum
of three weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in the figure until water comes out of the
openings at the side for more than a minute (fig. 34).
34 35
0,5 L
4. Extract the tank from the appliance and fill with water.
5. Insert the filter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 35).
6. Insert the filter in the filter housing (fig. 36) and press as
far as it will go.
7. Close the tank with the lid (fig. 37), then replace the tank
in the machine.
36 37
When you install the filter, you must notify the appliance of its
presence.
8. Press the
icon (B2) to enter the menu;
9. Press or (fig. 7) until “Install filter” is
displayed.
10. Press the
OK
icon (fig. 4).
11. Enable?” is displayed.
12. Press the
OK
icon to confirm the selection. “HOT WATER
Press OK” is displayed.
13. Position a container under the hot water spout (min. ca-
pacity: 500 ml) (fig. 5).
14. Press the OK icon to confirm the selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed.
15. After the flow of hot water stops, the appliance automati-
cally resets to “Ready for coffee” status.
The filter is now active and you can use the coffee machine.
soft water
slightly
hard water
hard water
very hard
water
●
● ●
● ● ●
● ● ● ●