DeLonghi ETAM29.51X, Инструкция по эксплуатации

Страница: 18 / 21

17
9. Deliver hot water by turning the hot water/steam dial
(B1) to the I position.
12. Deliver at least 500 ml of hot water, then turn the hot water/
steam dial to the O position.
The filter is now active and you can use the coffee machine.
Replacing the filter
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter:
1. Extract the tank (A15) and exhausted filter (C3);
2. Take the new filter out of its packet and proceed as illus-
trated in points 2 to 10 in the previous section.
The new filter is now active and you can use the coffee machine.
TECHNICAL DATA
Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power: 1450W
Pressure: 1,5MPa (15 bar)
Max. water tank capacity: 1,4 l
Size: LxDxH: 195x480x340 mm
Cord length: 1050 mm
Weight: 9,1 kg
Max. beans container capacity: 150 g
The appliance complies with the following EC
directives:
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent amendments;
• European Standby Regulation 1275/2008
• Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.
EXPLANATION OF LIGHTS
LIGHTS DISPLAYED POSSIBLE CAUSE SOLUTION
FLASHING
Insufficient water in the tank (A18). Fill the tank (A18) with water and/or insert it
correctly, pushing it as far as it will go until it
clicks into place.
FLASHING
The grounds container (A14) is full. Empty the grounds container and drip tray
(A13), clean and replace (fig. 18). Important:
when removing the drip tray, the grounds con-
tainer MUST be emptied, even if it contains few
grounds. If this is not done, when you make the
next coffees, the grounds container may fill up
more than expected and clog the machine.
ON
After cleaning, the grounds container has not
been replaced. Remove the drip tray (A13) and insert the
grounds container.
ON + FLASHING
The coffee beans have run out. Fill the beans container (fig. 9).
The pre-ground coffee funnel is clogged. Empty the funnel with the help of a brush as
described in the section “Cleaning the pre-
ground coffee funnel” (page 15).
FLASHING + ON
The “pre-ground coffee” function has been se-
lected without placing any pre-ground coffee
in the funnel. Place pre-ground coffee in the funnel or dese-
lect the “pre-ground” function (fig. 13).
FLASHING
The machine must be descaled. The descaling procedure described in the section
“Descaling” needs to be performed as soon as
possible (page 16).