DeLonghi ESAM5400, Инструкция по эксплуатации

Страница: 17 / 24

17
hamic or acetic based descalers. Their use in-
validates the guarantee. Failure to descale the
appliance as described above also invalidates the
guarantee.
1. Turn the machine on.
2. Press the P button to enter the menu.
3. Turn the selector knob until the light
flashes. Press : the and lights
alternates.
4. Completely empty the water tank (a7); em-
pty the drip tray (a11) and the coffee groun-
ds container, then reinsert them.
Pour the descaler diluted with water (respec-
ting the proportions indicated on the desca-
ler pack) into the water tank and reinsert it.
Place an empty container with a minimum
capacity of 1.5 litres under the hot water
spout.
Important! Danger of burns!
hot water containing acid flows from the cap-
puccino maker. avoid contact with splashes of
water.
5. Press the button: the descaling pro-
gramme starts and the descaler liquid comes
out of the cappuccino maker.
The descale programme automatically per-
forms a series of rinses and pauses to remo-
ve limescale deposits from inside the machi-
ne.
after about 30 minutes, the water tank is empty.
The oK and lights comes on and the
and lights come on.
6. The appliance is now ready for rinsing throu-
gh with clean water. remove the water tank,
empty, rinse under running water, fill with
clean water and replace.
7. empty the container used to collect the de-
scaler solution and replace it empty under
the cappuccino maker.
8. Press the button to start rinsing. hot
water comes out of the spout and and
lghts come on.
9. When the water tank is completely empty,
the and OK lights come on.
10. Press the button: the appliance
switches automatically off.
Before switching on the appliance, by pressing
the
button, empty the drip tray.
SETTING WATER HARDNESS
The light comes on after a period of time
established according to water hardness.
The machine is set by default for a hardness va-
lue of 4 (very hard water).
The machine can also be programmed according
to the hardness of the mains water in the various
regions so that the machine needs to be descaled
less often.
Measuring water hardness
1. remove the “ToTal hardneSS TeST” indi-
cator paper attached to this manual from its
pack.
2. immerse the paper completely in a glass of
water for one second.
3. remove the paper from the water and shake
lightly.
after about a minute, 1, 2, 3, or 4 red squares
form, depending on the hardness of the wa-
ter. each square corresponds to one level.
level 1
level 2
level 3
level 4
Set water hardness
1. Press the P button to enter the menu.
2. Turn the selector knob until the light is
selected.
3. Confirm the selection by pressing the
button.
4. Turn the selection knob and set the level
shown by the indicator paper (see previous
paragraph).
level 1
level 2
level 3
level 4
5. Press the button to confirm the set-
ting.
6. Press the button to exit the menu.