DeLonghi ECAM22.32 Series, Инструкция по эксплуатации

Страница: 15 / 20

14
PUSH
1. Remove the drip tray and the grounds container (fig. 21);
2. Empty the drip tray and grounds container and wash them;
3. Check the red condensate tray and empty if necessary.
4. Replace the drip tray and grounds container.
Cleaning the inside of the coffee machine
Danger!
Before cleaning internal parts, the machine must be turned
off (see “Turning off”) and unplugged from the mains power
supply. Never immerse the machine in water.
1. Check regularly (about once a month) that the inside of the
appliance (accessible after removing the drip tray) is not
dirty. If necessary, remove coffee deposits with a brush and
a sponge.
2. Remove the residues with a vacuum cleaner (fig. 23).
Cleaning the water tank
1. Clean the water tank (A9) regularly (about once a month)
and each time you replace the water softener filter (if
provided) with a damp cloth and a little mild washing up
liquid.
2. Remove the filter (if present) and rinse with running water.
3. Replace the filter (if provided), fill the tank with fresh
water and replace the tank.
Cleaning the coffee spouts
1. Clean the coffee spouts with a sponge or cloth (fig. 24A).
2. Check the holes in the coffee spout are not blocked. If
necessary, remove coffee deposits with a toothpick (fig.
24B).
Cleaning the pre-ground coffee funnel
Check regularly (about once a month) that the pre-ground
coffee funnel (A6) is not blocked.
If necessary, remove coffee deposits with a brush.
Cleaning the infuser
The infuser (A12) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see “Turning
off” on page 9).
2. Remove the water tank.
3. Open the infuser door (fig. 25) positioned on the right side
of the machine.
4. Press the 2 red release buttons inwards and at the same
time pull the infuser outwards (fig. 26).
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISHWASHER
Do not use washing up liquid to clean the infuser as it may
damage it.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. Use a brush to remove any coffee residues left in the infuser
housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support, then push the PUSH symbol fully in until
it clicks into place.
Please note :
If the infuser is difficult to insert, before insertion, squeeze the
two levers shown in the figure to make it smaller.
7. Once inserted, make sure the two red buttons have popped
out again.
8. Close the infuser door.
9. Replace the water tank.
DESCALING
Descale the machine when the message “DESCALE” flashes on
the display.
Important!
Descaler contains acids which may irritate the skin and eyes.