9
4. Place a container with a minimum capacity of 500 ml
under the boiler outlet (A5) (fig. 4) and press the
button. Repeat this operation 5 times.
5. Empty the container and put it under the hot water/steam
spout (A12) (fig. 4).
6. Turn the hot water/steam dial to the
position (fig.
5) and deliver to empty the water tank (A3); then turn the
knob to the
○
position.
7. PROGRAMMING THE SETTINGS MENU
To access the menu, make sure the appliance is ready for use,
then press and hold the
button for 10 seconds until the
three buttons flash in sequence:
The appliance is now in programming mode.
Set the coffee maker as you wish, then exit the settings menu by
waiting for 15 seconds.
Please note:
If no selections are made for 15 seconds, the appliance automat-
ically exits programming and is ready for use again.
7.1 Setting coffee temperature
To modify the temperature of the water used to make the coffee,
proceed as follows:
1. Access the settings menu;
2. Press the
button to enter the coffee temperature
selection mode. The lights corresponding to the current
selection come on:
low
medium
high
3. The lights start flashing in sequence;
4. Press the button corresponding to the required
temperature:
low
medium high
5. The button flashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
7.2 Setting water hardness
The light (B7) indicating that the coffee maker needs descaling
comes on after a period of operation established according to
water hardness.
The appliance can also be programmed according to the hard-
ness of the mains water in the various regions so that descaling
needs to be performed more or less frequently.
Proceed as follows:
1. Access the settings menu;
2. Press the
button to enter the water hardness selec-
tion mode. The lights corresponding to the current selec-
tion come on:
soft
medium
hard
3. The lights start flashing in sequence;
4. Press the button corresponding to the water hardness in
your area:
soft water
medium
water
hard water
<10°dH
10°dH - 20°dH
>20°dH
<18°fH
18°fH - 36°fH
>36°fH
<180mg/l CaCo
3
180-360mg/l CaCo
3
>360mg/l CaCo
3
- The button flashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
7.3 Adjusting auto-off (stand-by)
To save energy, an auto-off function turns the appliance off
when not used for a long period. To turn it back on again, press
any button on the control panel.
1. Access the settings menu;
2. Press the
button to enter the auto-off time selection
mode. The lights corresponding to the current selection
come on:
9 min
30 min
3 hours
3. The lights start flashing in sequence;
4. Press the button corresponding to the required time:
9 min
30 min
3 hours
