DeLonghi Dedica EC 685.W, Инструкция по эксплуатации

Страница: 21 / 28

21
soft water medium
water hard water
<10°dH 10°dH - 20°dH >20°dH
<18°fH 18°fH - 36°fH >36°fH
<180mg/l CaCo
3
180-360mg/l CaCo
3
>360mg/l CaCo
3
- The button flashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
4.3 Adjusting auto-off (stand-by)
To save energy, an auto-off function turns the appliance off
when not used for a long period. To turn it back on again, press
any button on the control panel.
1. Access the settings menu;
2. Press the
button to enter the auto-off time selection
mode. The lights corresponding to the current selection
come on:
9 min
30 min
3 hours
3. The lights start flashing in sequen e;
4. Press the button corresponding to the required time:
9 min 30 min 3 hours
5. The button flashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
4.4 Default values (reset)
This resets all menu settings and programmed quantities back
to the default values.
To reset the default values, proceed as follows:
1. Position the steam spout over the drip tray;
2. Access the settings menu;
3. Turn the steam dial to the
position;
4. Press the button. The three lights flash simulta-
neously to confirm that the original settings have been
restored.
5. The and lights flash to indicate that the
steam dial must be closed again (
○
symbol).
When the steam dial has been closed, the appliance is ready for
use.
5. HOW TO MAKE ESPRESSO COFFEE
5.1 Tips for a hotter coffee
For hotter espresso c off ee, you should:
• You are recommended to warm the cups before making
c off ee by rinsing them with a little hot water.
• Attach the fil er holder to the appliance with the fil er in
place but without adding coffee . Using the same cup
as will later be used to make the c off ee, press the 1 cup
button and deliver hot water into the cup to heat it.
• Raise the c off ee temperature in the settings menu.
• Rest the cups you will be using on the cup warmer (
A4
)
which becomes hot during operation.
5.2 How to prepare espresso coffee using pre-
ground coffee
1. Place the ground c off ee fil er ( C2 or C3 ) in the fil er holder
(fi . 6). To make one c off ee, use the fil er with the
symbol on the bottom, to make two c off ees, use the fil er
with the symbol on the bottom.
2. To make just one c off ee, place one level measure of pre-
ground c off ee (about 7 g) in the fil er (fi . 7). To make two
c off ees, place two loosely filled measures (about 7+7 g) of
pre-ground c off ee in the fil er. Fill the fil er a little at a time
to prevent the pre-ground c off ee from overfl wing.
Important:
For correct operation, before filling with pre-ground c off ee,
make sure there are no c off ee residues left in the fil er from the
last time you made c off ee.
3. Distribute the pre-ground c off ee evenly and press lightly
with the presser (fi . 8).
Correct pressing of the pre-ground c
off ee is essential to
obtain a good espresso. If you press too firml , the c off ee
will be delivered slowly and will be strong. If you press
too lightly, the c
off ee will be delivered quickly and will be
weak.
4. Remove any excess c off ee from the rim of the fil er holder
and attach the fil er holder to the appliance. To attach cor-
rectly, align the fil er holder handle with the INSERT sym-
bol (fi . 9), attach the fil er holder and rotate the handle
towards the right until aligned with the CLOSE symbol.
5. Place the cup or cups under the fil er holder spouts (fi .
10).
6. Make sure the lights corresponding to the c off ee buttons
are on, then press the or c off ee button. The
appliance proceeds to make the c off ee and delivery is in-
terrupted automatically.
7. To remove the fil er holder, turn the handle from right to
left.