H
ow to dehumidify
1) Plug the appliance into a mains socket. The power light comes on to show the appliance
is connected to the mains.
2) Check that the “tank full/no tank” indicator light is off.
3) Turn the humidistat to the “CONTINUOUS” position and the mode selector to the
“DEHUMIDIFICATION” position. The dehumidification pause light comes on during the first
three minutes (safety device), followed by the dehumidification light.
4) Select maximum or minimum fan speed (the relevant light comes on).
When the humidity in the room has reached the required level, slowly turn the humidistat knob
anticlockwise until the dehumidifying light goes out. The dehumidifier will then keep the
humidity in the room at the selected level automatically.
Note: When dehumidifying, the appliance not only dehumidifies but also slightly warms the air
(1-2°C hotter than room temperature)
H
ow to heat
1) Plug the appliance into a mains socket.
2) Turn the thermostat knob to position 5.
3) Turn the mode selector to the “HEATING” position. The heating light comes on and the
appliance starts up.
4) Select the economy ( /
1
= 800 W) or maximum ( /
2
= 1600 W) heating level on the
speed/heat selection button (the corresponding light comes on).
When the temperature in the room has reached the required level, slowly turn the thermostat
knob anticlockwise until the heating light goes out.
The thermostat will then keep the temperature in the room at the selected level automatically.
C
ombined mode, (dehumid heating)
1) Plug the appliance into a mains socket.
2) Check that the “tank full/no tank” warning light is off.
3) Turn the humidistat knob to the “CONTINUOUS” position.
4) Rotate the mode selector to the “COMBI” position. The ( )light comes on together with
the dehumidification pause light for the first three minutes (safety device), followed by the
dehumidification light.
5) Select maximum or minimum fan speed (and consequently the electrical power). In this
mode, the electrical power will be 1,990 W or 1.190 W.
6) When the humidity in the room has reached the required level, slowly turn back the
humidistat knob anticlockwise until the dehumidifying and heating lights go out. The
dehumidifier will then keep the humidity at the set level.
Note: The appliance only stops completely when the level of humidity set is reached. If the
tank is full, the tankfull warning light comes on and the refrigerant circuit stops however
the heater will continue to work.
18
S e l e c t i n g o p e ra t i n g m o d e s
DE320GB 28-05-2001 16:59 Pagina 18
