
GB
29
operation
starting a wash cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water
pressure between 0.04 MPa and 1.00 MPa).
2. Open the door. Pull out the baskets, load the dishes and cutlery and push the baskets back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Close the dishwasher door. A click should be heard when the door is closed correctly. Do not
slam the door.
5. Press the button.
6. Press the
P
button to select the wash cycle programme based on the loading and soil
requirements. Please refer to the section
Wash Cycle Table
. The programme indicator will light
up for the selected programme.
7. Press the button to start the washing programme.
changing a programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle has
been running.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, close the door and press the button to pause
the wash programme, then press and hold the
P
button for 3 seconds until the unit becomes
standby state. Press the
P
button again to select the required new programme. Press the
button to start the new programme. The unit will start the new washing cycle shortly.
at the end of a programme
At the end of a programme, the dishwasher will beep.
If you open the dishwasher’s door during the washing cycle and then close it, the
dishwasher will continue the current washing programme after 10 seconds.
DDWTT17-TTS19_IB_2L_190619_grace.indb 29
19/6/2019 4:58 PM