11
6. ALARMS SHOWN ON DISPLAY
ALARM
CAUSE
SOLUTION
Tank (A6) missing or incorrectly
positioned
Place the tank back in its correct position (see para-
graph “2.1 Draining into the tank”)
Tank full
Empty the tank (see paragraph “2.1 Draining into the
tank””)
Room temperature too low (see op-
erating limits in chap. “5. Technical
Specifications”)
Increase the ambient temperature if possible
Humidity in room too low or too high for
correct measuring (see operating limits
in chap. “5. Technical Specifications”)
Move the appliance to another room with humidity
and temperature levels within the operating limits: if
the problem persists, call the Service Centre.
Faulty probe
Contact the Service Centre
7. TROUBLESHOOTING
Below is a list of possible malfunctions.
If the problem cannot be resolved using the proposed solution, contact the Service Centre.
PROBLEM
CAUSE
SOLUTION
The appliance is operating in dehumid-
ifying mode, but the humidity does not
decrease
The filter is clogged
Clean the dust filter (para. “4.2 Cleaning
the dust filter”)
Either the temperature or humidity in the
room is too low
In certain conditions the appliance will
not dehumidify: check the operating lim-
its of the appliance (see chapter “5. Tech-
nical Specifications”). In certain cases, it
is recommended to heat the room need-
ing to be dehumidified.
The set relative humidity level is too high Set a lower humidity value (see para.
“3.1 Dehumidifying mode”).
