DeLonghi CTL660, Инструкция по эксплуатации

Страница: 5 / 8

CTL660-680
5
Electrical Requirements (UK only)
Before using this appliance ensure that the voltage indicat-
ed on the product corresponds with the main voltage in
your home, if you are in any doubt about your supply con-
tact your local electricity company.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity.Should this plug not fit the socket out-
lets in your home, it should be cut off and replaced with a suitable
plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should
therefore be properly disposed of, (having removed the fuse) and not
left where children might find it and plug it into a supply socket - with
the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets
that can be switched off when the machine is not in use.
Important: the wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to
the terminal in the plug which is marked with the letter
E or by the
earth symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal
which is marked with the letter
N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter
L or coloured red.
When wiring the plug, ensure that all strands of wire are securely
retained in each terminal. Do not forget to tighten the mains lead
clamp on the plug. If your electricity supply point has only two pin
socket outlets, or if you are in doubt, consult a qualified electrician.
Should the mains lead ever require replacement, it is essential that this
operation be carried out by a qualified electrician and should only be
replaced with a flexible cord of the same size.
If the plug is a moulded-on type the fuse cover must be refitted. If the
fuse cover is lost, the plug must not be used until a replacement cover
is obtained. The colour of the correct replacement fuse cover is that of
the coloured insert in the base of the fuse recess or elsewhere on the
plug. Always state this colour when ordering a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362
should be fitted.
This appliance conforms to the Norms EN 55014 regarding the sup-
pression of radio interference.
Green and Yellow to
Earth
Blue to
Neutral
13 amp
Fuse
Brown to
Live
Cord Clamp
Warning
this appliance must be earthed
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE