4
Use
BEFORE USING FOR THE FIRST TIME
• Clip excess cord into the cord storage clips underneath the
toaster.
• As with all new heating elements, your toaster may emit
a slight burning or ‘new’ smell when it is first switched on.
This is normal and not a cause for concern.
• To eliminate the ‘new’ smell at the first use, operate the to-
aster on a medium setting without any bread inside. Ensure
the room is well ventilated during this operation.
TO USE YOUR TOASTER
• Make sure than the ON lever (
D
) is at the rest position. Move
the browning control dial (
B
) to the desired setting.
• Connect the appliance to the electrical outlet.
• Insert the slices of bread into the bread toasting slots (
A
)
and lower the lever (
D
) until it is all the way down.
Note: If the appliance is not connected to the elec-
trical outlet, the lever (D) will not stay down.
• When the toasting is finished, the lever returns to the rest
position, raising the toasted bread slices at the same time.
• If the bread is not sufficiently toasted, select a darker de-
gree of toasting by turning the browning control dial (
B
).
• The toasting can be interrupted at any time by pressing the Stop/
Cancel button (
F
). Never lift the lever (
D
) to cancel toasting.
Caution: the bread toasting slots become very hot
during operation. Do not touch.
Defrost function
Frozen slices of bread may be toasted by pressing the Defrost
button (
E
) immediately after lowering the lever (
D
); the toasting
cycle will be lengthened in order to achieve the desired brow-
ning. The defrost indicator light will remain lit while the defrost
function is in use.
Reheat function
To warm toast that has popped up but gone cold, lower the lever
(
D
) again and then press the ‘Reheat’ button (
G
). Please note
that this is fixed reheat time which cannot be adjusted by the
browning control. The reheat function can be cancelled at any
time by pressing the Stop/Cancel button (
F
). The reheat indi-
cator light will remain lit while the reheat function is in use.
SUGGESTIONS FOR USE
• Select a lower setting for light browning, for toasting one
slice only or for dry bread.
• When toasting a single slice of bread, you may notice a va-
riation in toast colour from one side to the other – this is
normal.
• Dry/stale bread toasts more quickly than fresh bread, and
thinly sliced bread toasts more quickly than thickly sliced
bread. Therefore the browning control should be set at a
lower setting than usual.
• For best results ensure that the bread slices are of an even
thickness, freshness and size.
• In order to achieve uniform browning we recommend that
you wait a minimum of 30 seconds between each toasting
so that the heating control can reset. Alternatively select a
lower setting when additional toasting is carried out.
PRECAUTIONS
• Never use the appliance when it is empty (when there is no
bread inside) except on first use.
• Do not use very thin or broken slices of bread.
• Do not insert other foods that may drip during the cooking
process. In addition to making the cleaning procedure more
difficult, these may cause fires.
• Clean the crumb tray regularly: crumbs can smoke or burn.
• Do not insert (by force) foods that are too big for the slots.
• Do not insert forks or other utensils into the toaster in order
to remove bread. As well as damaging the toaster, there is a
high risk of electric shock.
• Should some toast remain blocked in the toaster, remove
the plug from the mains, wait for the toaster to cool down
until it is safe to touch, then turn the toaster over and shake
it gently.
CARE AND CLEANING
•
Before cleaning, unplug your toaster and let it cool down.
• The external part of the appliance must be cleaned with a
soft cloth. Do not use abrasive detergents that can ruin the
surface.
• DO NOT IMMERSE IN WATER.
• After each use, remove the plug from the electrical outlet
and empty the crumb collection tray that is under the ap-
pliance.
DO NOT TOUCH ANY PART OF THE TOASTER WITH SHARP OR
METAL UTENSILS, ESPECIALLY INSIDE THE BREAD TOASTING
SLOTS. RISK OF ELECTRIC SHOCK.
Service and Customer Experience
• If the cord is damaged it must, for safety reasons, be repai-
red by De’Longhi or an authorised De’Longhi repairer.
• Please refer to the enclosed guarantee leaflet for service
and assistance details.
1761034IDL
/
06.12
Содержание CTJ2003 Series
Страница 2: ...2 Description ...
