• Step 4.
INSTALL
HORIZONTAL
BEAM
• For the long side sleeve of the pool:
• For the short side sleeve of the pool:
• Step 5.
INSTALL
HORIZONTAL
BEAM
AND L-TUBE
• Step 6.
INSTALL
HORIZONTAL
BEAM
AND
U-TUBES
Fill the pool with water
• WARNING!
DO NOT
leave pool unattended while filling with water.
• WARNING!
If more than 1~2 inches of water collects on any one side before you start filling in the centre, the pool is not level enough, and must
be corrected! Pull out the drain plug, release the water completely, disassemble the pool completely, locate the pool on a level surface, repeat set
up instruction.
• WARNING! DO NOT OVERFILL
as this could cause the pool to collapse. In times of heavy rainfall you may need to empty some of the water to
ensure the level is correct.
•
1. Make sure the drain fitting is plugged securely and the cap is in place. Start filling the pool with water. After about 1-inch of water is on the
bottom, stop filling and smooth wrinkles out of the bottom of the pool. Pull the outer wall out from the top edge, all around the bottom of the pool,
so that it fills evenly.
•
2. Continue filling the pool until water level is reached as shown in the
below image
