4
• Step 3: Install the motor and mains cable
• Connect the cable from the control panel to the cable that comes from the mains adapter box. Plug in the mains cable to the adapter box.
• Use cable ties to secure the mains cables.
Operation
1. Touch the up/down button to adjust the height of the desk, keep pressing the up/down button for 2 seconds to continue adjustment of the height,
the desktop run to its lowest point will display “bot”, the desktop at its highest point the display shows “top”.
• 2.
Key button:
1,2,3,4 are the four height memory buttons.
Long press the button for approximately 3 seconds to store the current height.
• 3. Long press for 5 seconds buttons 3 and 4 (at the same time), ‘
AS
r
’ (reset) indication will appear.
Press the down arrow button until the lifting table lowers to the lowest position and rebounds to rise to a stop. The display shows the lowest height “bot”.
Release the button, the reset is over and the table can be used normally.
• 4. The desk has two
USB
ports and one Type-C port, they can supply power for other electrical devices and can support the following charging
protocols, Type-C output: 5V3A/9V2A/12V1.5A, Type-A output: 3.6-6.5V2.4A/6.5-9V2A/12V1.5A, total output power of single port - 18W Max.
When the desk is moving, the power to the outputs will stop, when height adjustment stops power to the outputs will restart.
• 5. Short press the “
LOCK
” button to activate the
child lock function.
This will stop the desk operating if the buttons are accidentally touched.
The screen will show “Loc” and beep when the desk is locked.
Press the “LOCK” button (beep will sound) again to unlock.
• 6. Long press the up and down button to switch the
sensitivity level.
Press the up and down buttons again to scroll through the sensitivity settings:
When the screen shows “A-0”, it means the anti-collision function is off, “A-1” means the anti-collision sensitivity is in level 1, “A-2” means the anti-
collision sensitivity is in level 2, “A-3” means the anti-collision sensitivity is in level 3. Level 3 is the highest sensitivity.
Troubleshooting
•
RESET
: When the
LED
displays “
AS
r
” press the down button until the desk reaches its lowest height and rebounds to stop. The reset has
completed.
• When the desk does not work and the
LED
shows
“E01”
or
“E02”
, wait 18 minutes before trying to operate again.
• If the down button does not work, check the cable connections and then turn the power off for at least 10 seconds. Turn on the power and press
the down button to start the
RESET
process when the
LED
displays “
AS
r
”.
• If none of the above processes work please contact Dellonda Customer Service.
Step 3
LOCK
