3
Specification
Assembly
• Put the main body up-side-down (Fig.1). Slide Deco. Board (Fig.1.6) onto Base Bracket (Fig.1.5).
• Put the plug (Fig.1.8) and power supply cord through the holes on the centre of Base Cover (Fig.1.4) and Base (Fig.1.3).
• Then slide Base Cover (Fig.1.4) , Base (Fig.1.3) and Washer (Fig.1.2) onto Base Bracket (Fig.1.5) respectively.
•
Fix Washer (Fig.1.2), Base (Fig.1.3), Base Cover (Fig.1.4) and Base Bracket (Fig.1.5) with Screw M6*20 (Fig.1.1).
•
Clip the power supply cord with Cord Clip (Fig.1.7) and fix it onto Base (Fig.1.3) with Screw (Fig.1.9).
•
Stand the unit correctly (Fig.2). Fix L Bracket (Fig.2 .13) onto Aluminium Fixtures (Fig.2.10) with Screw M8*6 (Fig.2.12) & M4*6 (Fig.2.11)
respectively.
•
Then slide L Bracket (Fig.2.13) into the holes of Control Box (Fig.2.14).
•
Fix L Bracket (Fig.2.13) onto Control Box (Fig.2.14) with Screw M6*16 (Fig.2.15).
Operation
• Plug in the unit to a mains supply.
• Press
LED
Lighting Switch (Fig.2.18) to switch on or off the
LED
lighting.
• Press Heater Switch (Fig.2.16) to position “–” to switch on the heater directly.
• Press Heater Switch (Fig.2.16) to position “=”,
IR
sensors are activated. The Sub Heating Element will come on
immediately.
IR
Sensor indicator Light (Fig.2.17) starts to flash.
• When people or other objects are inside the sensing area (within about 0.6m around the heater body),
IR
Sensor
Indicator Light (Fig.2.17) lights up, and the main heating element is switched on automatically, while the sub
heating element turns off automatically. When people or other objects leave the sensing area, the main heating
element will switch off after 5 seconds, while the sub heating element is switched on again automatically.
IR
Sensor
LED
starts to flash again.
• Note:
IR
sensing distance may differ from different material and colour. If there is some mirrored material
around the unit, i.e. glass mirror, stainless steel mirror, aluminium mirror, etc, the sensing distance may extend
to 3.5m.
• Fig.3,
DO NOT
leave items unattended in the indicated areas.
Maintenance
• WARNING:
Allow to cool down before handling or moving.
• Cleaning: Unplug the unit before cleaning. It should be wiped with wet cloth.
DO NOT
use too much water.
• This heater cannot be serviced by the user. Contact Dellonda.
fig.1
fig.3
fig.2
Model
DG62
DG63
Power:
1200W
1600W
Supply:
230V
230V
Table Top Diameter:
Ø50cm
Ø50cm
Base Diameter:
Ø40cm
Ø40cm
Table Height:
65cm
95cm
Mains Cable Length:
1.8m
1.8m
IP Rating:
IP44
IP44
