Advanced Troubleshooting: Dell XPS 600 Service Manual
adtshoot.htm[4/10/2014 9:50:46 PM]
A possible expansion
card failure has
occurred.
1. Determine if a conflict exists by removing a card (not a graphics card) and
restarting the computer (see "
2. If the problem persists, reinstall the card that you removed, remove a
different card, and then restart the computer.
3. Repeat this process for each card. If the computer starts normally,
troubleshoot the last card removed from the computer for resource
conflicts.
4. If the problem persists, see "Contacting Dell" in your
Owner's Manual
for
instructions on obtaining technical assistance.
Another failure has
occurred.
Ensure that the cables are properly connected to the system board from
the hard drive, CD drive, and DVD drive (see "
").
If there is an error message on your screen identifying a problem with a
device (such as the floppy drive or hard drive), check the device to make
sure it is functioning properly.
The operating system is attempting to boot from a device (such as the
floppy drive or hard drive); check system setup (see "
make sure the boot sequence is correct for the devices installed on your
computer.
If the problem persists, see "Contacting Dell" in your
Owner's Manual
for
instructions on obtaining technical assistance.
Beep Codes
Your computer might emit a series of beeps during start-up if the monitor cannot display errors or problems. This series of
beeps, called a beep code, identifies a problem. One possible beep code (code 1-3-1) consists of one beep, a burst of three
beeps, and then one beep. This beep code tells you that the computer encountered a memory problem.
may fix the beep code errors in the following table. If the problem persists, see "Contacting
Dell" in your
Owner's Manual
for instructions on obtaining technical assistance.
Code
Cause
1-3-1 through 2-4-4 Memory not being properly identified or used
4-3-1
Memory failure above address 0FFFFh
If you hear one of the following beep codes, see "Contacting Dell" in your
Owner's Manual
for instructions on obtaining
technical assistance.
Code Cause
1-1-2 Microprocessor register failure
1-1-3 NVRAM
1-1-4 ROM BIOS checksum failure
1-2-1 Programmable interval timer
1-2-2 DMA initialization failure
1-2-3 DMA page register read/write failure
3-1-1 Slave DMA register failure
3-1-2 Master DMA register failure
3-1-3 Master interrupt mask register failure
3-1-4 Slave interrupt mask register failure
3-2-2 Interrupt vector loading failure
3-2-4 Keyboard Controller Test failure