Dell Networking W-IAP228 Wireless Instant Access Point
| Installation Guide
3
Table 1
W-IAP228 LED Status during Boot Up
Table 2
W-IAP228 LED Status during Operation
USB Console Port
The USB Micro-B console port allows you to connect the IAP to a terminal or a laptop for direct local
management. Use the included USB console cable to connect the IAP. You can download the necessary driver for
USB-UART adapter from
download.dell-pcw.com
under the
Tools & Resources
tab.
Use the following setting to access the terminal:
Ethernet Ports
The W-IAP228 Instant access point is equipped with two 10/100/1000Base-T (RJ-45) Gigabit Ethernet ports
(WAN and LAN port) for wired network connectivity. The WAN port supports 802.3at Power over Ethernet
(PoE), accepting 48 VDC (nominal) as a standard defined Powered Device (PD) from a Power Sourcing
Equipment (PSE) such as a PoE midspan injector.
These ports have RJ-45 female connectors with the pin-outs shown in
.
LED
Color/State
Meaning
System LED
Off
No power to IAP
Red
Initial power-up
Green - Flashing
IAP booting
Green - Steady
IAP ready and 1000Mbps Ethernet link established. The LED turns off
after 1200 seconds
Green - Yellow, 6 seconds
period
IAP ready and 10/100Mbps Ethernet link established. The LED turns off
after 1200 seconds
LED
Color/State
Meaning
System LED
Solid Red
General fault
One blink off every 3 seconds
Radio 0 fault (5 GHz)
Two quick blink off 0.5 seconds
apart cycled every 3 seconds
Radio 1 fault (2.4GHz)
Table 3
Console Settings
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
9600
8
None
1 None