Dell Vostro 3590, Руководство пользователя

Страница: 37 / 95

3 Affix the adhesive tape to secure the touchpad to the system.
4 Align and place the metal bracket under the plastic hold down.
5 Replace the two M2x2 screws to secure the metal bracket to the touchpad.
6 Install the:
a battery
b base cover
7 Follow the procedure in After working inside your computer .
Display assembly
Removing the display assembly
1 Follow the procedure in Before working inside your computer .
2 Remove the:
a base cover
b battery
c Removing the WLAN card
d Removing the WWAN card
3 Remove the eDP cable from its connector on the system board [1] and unroute the cable from the routing channel on the system fan
[2].
4 Peel off the adhesive tape securing the eDP cable to the system [3].
5 Unroute the eDP cable from the hook of the right LCD hinge and routing clips on the system [4].
6 Unroute the WLAN cables from the routing channel [5] .
7 Then, open the palm-rest assembly to at least 90-degrees and place the system on the edge of a table so that the palm rest is laying
flat on the table and the display assembly is over the edge.
Removing and installing components 37