4. Disassembly and Assembly Procedures
Use a Philips-head screwdriver to tighten 5pcs
screws for locking the front bezel with the panel.
(No.1~5 screw size=M2x2.7, Torque=3
±0.5
kgfxcm)
Stick 2pcs acetate tape to fix the panel lamp cables.
Tear off all the double-faced adhesive tapes which
sticked on the back of the function key cable, and
then fix the cables with the double-faced tape. Use a
proper tool to connect the function key cable to the
connector of the interface board.
S12
2
S11
Assemble the front
then u
bezel with the assembled unit,
se a Philips-head screwdriver to tighten 2pcs
screws(left and right) for locking the front bezel.
(No.1~2 Screw size= M3x0.5x4, Torque=3
~4
kgfxcm)
1
3
5
2
4
1
S13
S14
Take a USB board, a USB hub and a connect cable.
Connect the cable to the USB board, then locate the
USB board into the USB hub. Stick 1pcs aluminum
foil on one side of the USB hub, then locate the
USB unit into the hook of a rear cover. Use a
Philips-head screwdriver to tighten one screw for
locking the USB unit with the rear cover. Tear off the
adhesive paper of the left and right side of rear cover.
(No.1 screw size=M3x6, Torque=4
±
0.5
kgfxcm)
S15
1
Stick 1pcs aluminum foil on the specific position to fix
the function key cable as the picture below shown.
