Dell Storage Center SC200, Руководство по обслуживанию

Страница: 27 / 36

Replacing Rack Rails
Dell Compellent 23
e
Turn off line wrapping.
f
Press Enter several times to initiate the connection. The terminal echoes back to
indicate that connectivity has been established. If the prompt > is not displayed,
verify that the communications settings are correct and the physical serial
connection is good.
g
Enter the following command to switch to developer mode:
shellaccess developer
h
Enter the following command and note the jbod index and enclosure values
displayed in the output:
jbod enclosure show
i
Enter the following command to reset the Service tag. Replace
jbod_index
and
enclosure
with the values determined in Step h and
service_tag
with the value
determined in Step a .
jbod enclosure setServiceTag
<jbod_index> <enclosure>
ServiceTag
"
<service_tag>
"
23
Perform a Phone Home and contact Dell Technical Support Services as described on
page 24 .
Replacing Rack Rails
Rack rails are used to install SC200 and SC220 enclosures into a rack.
Use this procedure to replace rack rails.
1
Shut down the controller(s) and enclosure(s) as described on page 8 .
2
Remove the enclosure from the rack rails.
3
Remove the rack rails from the rack.
4
Install the replacement rack rails in the rack.
5
Install the enclosure in the rack rails.
6
Start up the controller(s) and enclosure(s) as described on page 24 .
Data Bits 8
Stop Bits 1
Flow Control Hardware or default
Note:
To facilitate troubleshooting, enable logging for the session.
Setting Value
Note:
This procedure contains high-level steps. For detailed instructions, see
Rack Installation Instructions at http://support.dell.com/support/edocs/systems/
md1220/en/index.htm .