4. Disassembly and Assembly Procedures
Adjust the bracket chassis to the correct position,
then use a Philips-head screwdriver to tighten 2pcs
screws for locking the bracket with panel module.
Use a Hex-head screwdriver to lock 2pcs screws for
locking the VGA connector.
(No.1~2 screw size=M3x2.6, Torque=4
0.5
kgfxcm;
No.3~4 screw size=M3x8, Torque=6
±0.5
kgfxcm)
±
S13
S10
S12
Connect the function key cable to the connector of
board, then tear off the 3pcs double-faced tape on
the back of the back and fix the cable on the bracket
as the picture below shown.
Take out 1pcs panel assembled module with front
bezel and function key board from the carton, and
then examine the panel surface according to
inspection criteria. Turn over the panel, and then
place screen faced down for later assembling.
S8
Move the bracket close to the panel, then connect
LVDS cable to the connector of the panel. Turn over
the bracket and put it on the back of panel.
S9
2
S11
3
4
1
Paste 1pcs aluminum foil on the specific position to
fix the LVDS cable as the picture below shown.
Connect the panel lamp cable to the connector of
the panel module, then paste 1pcs aluminum foil to
fix the panel lamp cable as the picture below shown.