Version
Description
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
pre-6.1.1.0
Introduced on the E-Series.
Related Commands
•
— display the interface routing status and configuration.
ip route
Assign a static route to the switch.
Syntax
ip route [vrf
vrf-name
] ip-address mask {
ip-address
| interface [
ip-address
]}
[
distance
] [permanent] [tag
tag-value
] [vrf
vrf-name
] [weight
weight-value
]
To delete a specific static route, use the
no ip route
destination mask
command.
To delete all routes matching a certain route, use the
no ip route destination mask
command.
Parameters
vrf
vrf-name
(Optoinal) Enter the keyword
vrf
and then the name of the VRF to configure a static
route corresponding to that VRF. Use this VRF option after the
ip route
keyword to
configure a static route on that particular VRF.
destination
Enter the IP address in dotted decimal format of the destination device.
mask
Enter the mask in the slash prefix format (/x) of the destination IP address.
ip-address
Enter the IP address of the forwarding router in dotted decimal format.
interface
Enter one of the following keyword followed by the interface information
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then
the stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE
then the
stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the stack/
slot/port[/subport] information.
•
For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE
then the stack/
slot/port/subport information.
•
For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE
then the
stack/slot/port information.
•
For a Loopback interface, enter the keyword
loopback
then a number from 0 to
16383.
•
For the Management interface on the stack-unit, enter the keyword
ManagementEthernet
then the slot/port information.
•
For a port channel interface, enter the keywords
port-channel
then a number.
•
For a Null interface, enter the keyword null then the Null interface number.
•
For a VLAN interface, enter the keyword
vlan
then a number from 1 to 4094.
IPv4 Routing
773
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...
