Dell S6100, Руководство по настройке

Страница: 759 / 1743

proto=89
IP: s=40.40.40.40 (local), d=224.0.0.6 (Te 1/1/4/1), len 28, sending broad/
multicast
proto=2
IP: s=0.0.0.0, d=30.30.30.30, len 100, unroutable
ICMP type=8, code=0
IP: s=0.0.0.0, d=30.30.30.30, len 100, unroutable
ICMP type=8, code=0
Usage Information
To stop packets from flooding the user terminal when debugging is turned on, use the
count
option.
The
access-group
option supports only the equal to (
eq
) operator in TCP ACL rules. Port operators not equal
to ( neq ), greater than ( gt ), less than ( lt ), or range are not supported in access-group option (refer to the
following example). ARP packets (
arp
) and Ether-type (
ether-type
) are also not supported in the
access-
group
option. The entire rule is skipped to compose the filter.
The
access-group
option pertains to:
• IP protocol number: from 0 to 255
• Internet control message protocol (
icmp
) but not the ICMP message type (from 0 to 255)
• Any internet protocol (
ip
)
• Transmission Control Protocol (
tcp
) but not on the
rst
,
syn
, or
urg
bits
• User Datagram Protocol (
udp
)
In the case of ambiguous access control list rules, the
debug ip packet access-control
command is
disabled. A message appears identifying the error (refer to the Example below).
Example (Error
Messages)
Dell# debug ip packet access-group test
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
Dell#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is turned off
Dell#
ip address
Assign a primary and secondary IP address to the interface.
Syntax ip address ip-address mask [secondary]
To delete an IP address from an interface, use the
no ip address [ ip-address ]
command.
Parameters
ip-address Enter an IP address in dotted decimal format.
mask Enter the mask of the IP address in slash prefix format (for example, /24).
IPv4 Routing 759