Dell S6100, Руководство по настройке

Страница: 382 / 1743

neighbor default-originate
Inject the default route to a BGP peer or neighbor.
Syntax neighbor { ip-address | peer-group-name } default-originate [route-map map-name ]
To remove a default route, use the
no neighbor { ip-address | peer-group-name } default-
originate
command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to set the default route of all routers in that peer group.
route-map map-
name
(OPTIONAL) Enter the keyword
route-map
then the name of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you apply a route map to a BGP peer or neighbor with the
neighbor default-originate
command
configured, the software does not apply the set filters in the route map to that BGP peer or neighbor.
When you configure a route-map for a BGP peer or peer group with the
neighbor default-originate
command, the command checks for the existence of the route in BGP RIB.
Route-map configuration on a BGP peer or peer group works only when the LOC-RIB contains at least one route.
When you apply a default route to a BGP peer or peer group using the
neighbor default-originate
command, changes to the configured default route-map are applied to the BGP peer or peer group only after a
382 Border Gateway Protocol