Dell S6100, Руководство по настройке

Страница: 298 / 1743

count for that new interval commences from zero. If ACL logging was stopped previously because the configured
threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-enabled after the logging interval
period elapses. ACL logging is supported for standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You
can configure ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLs
that are associated with egress interfaces.
You can activate flow-based monitoring for a monitoring session by entering the
flow-based enable
command
in the Monitor Session mode. When you enable this capability, traffic with particular flows that are traversing
through the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both the ingress
and egress direction. Flow-based monitoring conserves bandwidth by monitoring only specified traffic instead all
traffic on the interface. This feature is particularly useful when looking for malicious traffic. It is available for Layer 2
and Layer 3 ingress and egress traffic. You may specify traffic using standard or extended access-lists. This
mechanism copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The
source port is the monitored port (MD) and the destination port is the monitoring port (MG).
Related Commands
• deny — assign a IP ACL filter to deny IP packets.
• ip access-list standard — create a standard ACL.
permit arp (for Extended MAC ACLs)
Configure a filter that forwards ARP packets meeting this criteria. This command is supported only on 12-port GE line cards with SFP
optics; refer to your line card documentation for specifications.
Syntax permit arp { destination-mac-address mac-address-mask | any} vlan vlan-id { ip-
address | any | opcode code-number } [count [byte]] [order] [fragments] [log
[interval minutes ] [threshold-in-msgs [count]][monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s sequence number.
• Use the
{ destination-mac-address mac-address-mask | any} vlan vlan-id { ip-
address | any | opcode code-number }
command.
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the
threshold-in-msgs
keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the
seq
,
permit
, or
deny
commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword
interval
followed by the time period in minutes at
which ACL logs must be generated. The interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is describing the traffic that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
298 Access Control Lists (ACL)