Dell S6100, Руководство по настройке

Страница: 211 / 1743

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the
monitor
option.
6.5.10 Expanded to include the optional QoS
order
priority for the ACL entry.
Usage Information
The
order
option is relevant in the context of the Policy QoS feature only. For more information, see the “Quality
of Service” section of the Dell Networking OS Configuration Guide .
The software cannot count both packets and bytes; when you enter the count byte options, only bytes are
incremented.
Related Commands
• ip access-list extended — create an extended ACL.
•
•
permit tcp — assign a permit filter for TCP packets.
• permit udp — assign a permit filter for UDP packets.
permit icmp
Configure a filter to allow all or specific ICMP messages.
Syntax permit icmp { source mask | any | host ip-address } { destination mask | any |
host ip-address } [ type ] [dscp] [ message-type ] [count [byte] | log] [order]
[monitor] [fragments] [no-drop]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s sequence number.
Access Control Lists (ACL) 211