Version
Description
8.3.11.1
Introduced on the Z9000.
8.4.2.3
Added support for IPv6 sFlow collectors and agents on the E-series, C-Series, and S-
Series.
8.4.1.1
Added support for IPv6 sFlow collectors and agents on the E-series.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Introduced S-Series Stacking.
8.1.1.0
Introduced on the E-Series.
7.7.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
6.5.1.0
Expanded the
no
form of the command to mirror the syntax used to configure.
6.2.1.1
Introduced on the E-Series.
Usage Information
You can configure up to two sFlow collectors (IPv4 or IPv6). If two collectors are configured, traffic samples are
sent to both.
The sFlow agent address is carried in a field in SFlow packets and is used by the collector to identify the sFlow
agent.
In sFlow, the agent address is a single invariant IPv4 or IPv6 address used to identify the agent to the collector. It is
usually assigned the address of a loopback interface on the agent, which provides invariance. The agent address is
carried as a field in the payload of the sFlow packets.
As part of the sFlow-MIB, if the SNMP request originates from a configured collector, Dell Networking OS returns
the corresponding configured agent IP in the MIB requests. Dell Networking OS checks to ensure that two entries
are not configured for the same collector IP with a different agent IP. Should that happen, Dell Networking OS
generates the following error:
%Error: Different agent-addr attempted for an existing
collector
.
Example
Dell(conf)# sflow collector 10.1.1.25 agent-addr 10.1.1.10 vrf management
sflow enable (Global)
Enable sFlow globally.
Syntax
sflow enable
To disable sFlow, use the
no sflow enable
command.
Defaults
Disabled.
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
1484
sFlow
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...