Dell S6100, Руководство по настройке

Страница: 1192 / 1743

redirect
Configure a rule for the redirect list.
Syntax redirect { ip-address | slot/port } | tunnel tunnel-id }[track <obj-id> ] { ip-
protocol-number | protocol-type [ bit ]} { source mask | any | host ip-address }
{ destination mask | any | host ip-address } [ operator ]
To remove this filter, use one of the following:
• Use the
no seq sequence-number
command if you know the filter’s sequence number.
• You can also use the no redirect { ip-address | slot/port }| tunnel tunnel-id }[track
<obj-id> ] { ip-protocol-number [ bit ] | protocol-type } { source mask | any |
host ip-address } { destination mask | any | host ip-address } [ operator ]
command.
Parameters
redirect Enter the keyword
redirect
to assign the sequence to the redirect list.
ip-address Enter the IP address of the forwarding router.
slot/port Enter the keyword
slot / port
followed by the slot/port information.
tunnel Enter the keyword
tunnel
to configure the tunnel setting.
tunnel-id Enter the keyword
tunnel-id
to redirect the traffic.
track Enter the keyword
track
to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
ip-protocol-number Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
•
icmp
for internet control message protocol
•
ip
for any internet protocol
•
tcp
for transmission control protocol
•
udp
for user datagram protocol
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following
TCP flags:
•
ack
= acknowledgement
•
fin
= finish (no more data from the user)
•
psh
= push function
•
rst
= reset the connection
•
syn
= synchronize sequence number
•
urg
= urgent field
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
1192 Policy-based Routing (PBR)