Dell S6100, Руководство по настройке

Страница: 1143 / 1743

show ip ospf topology
Display routers in directly connected areas.
Syntax show ip ospf [ process-id ] topology
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage Information To isolate problems with inter-area and external routes, use this command. In OSPF inter-area and external routes
are calculated by adding LSA cost to the cost of reaching the router. If an inter-area or external route is not of
correct cost, the display can determine if the path to the originating router is correct or not.
Example
Dell# show ip ospf 1 topology
Router ID Flags Cost Nexthop Interface Area
3.3.3.3 E/B/-/ 1 20.0.0.3 Gi 13/1 0
1.1.1.1 E/-/-/ 1 10.0.0.1 Gi 7/1 1
Dell#
Open Shortest Path First (OSPFv2 and OSPFv3) 1143