Dell S6100, Руководство по настройке

Страница: 1005 / 1743

Command Modes MULTIPLE SPANNING TREE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced.
Related Commands
• forward-delay — amount of time the interface waits in the Blocking State and the Learning State before
transitioning to the Forwarding State.
• hello-time — change the time interval between BPDUs.
msti
Configure multiple spanning tree instance, bridge priority, and one or multiple VLANs mapped to the MST instance.
Syntax msti instance {vlan range | bridge-priority priority }
To disable mapping or bridge priority, use the
no msti instance {vlan range | bridge-priority
priority }
command.
Parameters
msti instance Enter the MSTP instance. The range is from zero (0) to 63.
vlan range Enter the keyword
vlan
then the identifier range value. The range is from 1 to 4094.
bridge-priority
priority
Enter the keywords
bridge-priority
then a value in increments of 4096 as the
bridge priority. The range is from zero (0) to 61440.
Multiple Spanning Tree Protocol (MSTP) 1005