Dell S4048T, Руководство по настройке

Страница: 864 / 1277

Applying Layer 2 Match Criteria on a
Layer 3 Interface
To process Layer 3 packets that contain a dot1p (IEEE 802.1p) VLAN Layer 2 header, configure VLAN tags on a
Layer 3 port interface which is configured with an IP address but has no VLAN associated with it. You can also
configure a VLAN sub-interface on the port interface and apply a policy map that classifies packets using the
dot1p VLAN ID.
To apply an input policy map with Layer 2 match criteria to a Layer 3 port interface, use the
service-
policy input policy-name layer 2
command in Interface configuration mode.
To apply a Layer 2 policy on a Layer 3 interface:
1 Configure an interface with an IP address or a VLAN sub-interface
CONFIGURATION mode
Dell(conf)# interface fo 1/4
INTERFACE mode
Dell(conf-if-fo-1/4)# ip address 90.1.1.1/16
2 Configure a Layer 2 QoS policy with Layer 2 (Dot1p or source MAC-based) match criteria.
CONFIGURATION mode
Dell(conf)# policy-map-input l2p layer2
3 Apply the Layer 2 policy on a Layer 3 interface.
INTERFACE mode
Dell(conf-if-fo-1/4)# service-policy input l2p layer2
Applying DSCP and VLAN Match Criteria
on a Service Queue
You can configure Layer 3 class maps which contain both a Layer 3 Differentiated Services Code Point (DSCP)
and IP VLAN IDs as match criteria to filter incoming packets on a service queue on the switch.
To configure a Layer 3 class map to classify traffic according to both an IP VLAN ID and DSCP value, use the
match ip vlan vlan-id
command in class-map input configuration mode. You can include the class map
in a policy map, and apply the class and policy map to a service queue using the
service-queue
command.
In this way, the system applies the match criteria in a class map according to queue priority (queue numbers
closer to 0 have a lower priority).
Quality of Service (QoS) 864