Dell S3048-ON, Руководство по настройке

Страница: 581 / 1036

!
ip redirect-list test
seq 10 redirect 10.1.1.2 ip 20.1.1.0/24 any
seq 15 redirect 10.1.1.3 ip 20.1.1.0/25 any
seq 20 redirect 10.1.1.3 ip 20.1.1.0/24 any
Dell(conf-redirect-list)#
NOTE: Starting with the Dell Networking OS version 9.4(0.0), the use of multiple recursive routes with the same
source-address and destination-address combination in a redirect policy on an router.
A recursive route is a route for which the immediate next-hop address is learned dynamically through a routing protocol and acquired
through a route lookup in the routing table. You can configure multiple recursive routes in a redirect list by entering multiple
seq
redirect commands with the same source and destination address and specify a different next-hop IP address. In this way, the
recursive routes are used as different forwarding routes for dynamic failover. If the primary path goes down and the recursive route is
removed from the routing table, the
seq redirect
command is ignored and the next command in the list with a different route is
used.
Apply a Redirect-list to an Interface using a Redirect-group
IP redirect lists are supported on physical interfaces as well as virtual local area network (VLAN) and port-channel interfaces.
NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop and the destination port-
channel is shut down, the traffic is dropped. However, the traffic redirected to the destination port-channel is sometimes
switched.
To apply a redirect list to an interface, use the following command. You can apply multiple redirect-lists can be applied to a redirect-group. It
is also possible to create two or more redirect-groups on one interface for backup purposes.
Apply a redirect list (policy-based routing) to an interface.
INTERFACE mode
ip redirect-group redirect-list-name test l2–switch
•
redirect-list-name
is the name of a redirect list to apply to this interface.
• FORMAT: up to 16 characters
• You can use the l2–switch option to apply the re-direct list to Layer2 traffic.
NOTE: You can apply the l2–switch option to redirect Layer2 traffic only on a VLAN interface. This VLAN interface must
be configured with an IP address for ARP resolution. The Layer2 PBR option matches the layer2 traffic flow. If you un-
configure this option, then the Layer2 traffic is not matched.The Layer3 routing is not affected on the same interface on
which Layer2 PBR is applied. The port from which Layer2 packets egress and the destination MAC are re-written from
static ARP. Layer 2 packets with the re-written destination MAC are forwarded through the outgoing port on the same
incoming VLAN interface. The
l2-switch
option ensures that the outgoing VLAN and MAC-SA are changed and TTL
is not decremented.
To delete the redirect list from this interface, use the
no ip redirect-group
command.
In this example, the list xyz is applied to the GigabitEthernet 1/1 interface.
Example: Applying a Redirect-list to an Interface
Dell(conf-if-gi-1/1)#ip redirect-group xyz
Dell(conf-if-gi-1/1)#
Example: Applying a Redirect-list to an Interface
Policy-based Routing (PBR) 581