Dell PS-M4110, Руководство по установке

Страница: 59 / 70

53
Dell EqualLogic PS-M4110 Installation Guide Connecting a Computer to a Volume
6. Review the summary information ( Figure 29 ) and click Finish if the volume configuration is correct. Click
Back to make changes.
Figure 29: Create Volume
– Summary
Connecting a Computer to a Volume
When you create a volume, the PS Series group automatically generates an iSCSI target name, with the volume
name appended to the end of the target name. Each volume appears on the network as an iSCSI target.
An example of an iSCSI target name for a volume named dbvol is as follows:
iqn.2001-05.com.equallogic.5-4a0900-2f00000-007eca92d654f160-dbvol
To connect a computer to a volume:
1. Install and configure an iSCSI initiator on the computer. Hardware and software initiators are available from
different vendors. Configure your initiator using the instructions provided by the vendor.
Note: Dell recommends that you visit the Technical Support web site to obtain important information about
using initiators to access group volumes.
2. Make sure that the computer matches one of the volume’s access control records. To display the records for
a volume:
–
Using the CLI, enter the following command:
volume select volume_name access show