Steps
1.
If installed, disconnect the data cables from the PERC card and/or the power cables from the GPU
card.
2.
Press the expansion card latch and push down the latch to open it.
3.
Hold the expansion card by its edge, and pull the card up to remove it from the expansion card
connector and the system.
4.
Install the filler brackets by performing the following steps:
a. Align the slot on the filler bracket with the tab on the expansion card slot.
b. Press the expansion card latch till the filler bracket locks into place.
NOTE: Filler brackets must be installed in empty expansion-card slots to maintain FCC
certification of the system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
Figure 55. Removing an expansion card
1.
expansion card latch
2. expansion card
3. expansion card connector
Related Links
Safety instructions
Before working inside your system
After working inside your system
Installing an expansion card
Installing an expansion card
Prerequisites
1.
Follow the safety guidelines listed in the safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Remove the expansion card holder.
127
