Cable Routing Procedures for Dell PowerEdge R620 Systems
3
Contents
Introduction ............................................................................................................. 4
Section 1: Cabling a PowerEdge R620 with a CMA ................................................................ 4
1.1.
Connecting the cables to the system ................................................................... 4
1.2.
Routing the power cables through the strain reliefs ................................................. 5
1.3.
Installing the CMA .......................................................................................... 5
Section 2: Replacing a power supply on a PowerEdge R620 system with a CMA ........................... 8
2.1.
Replacing a power supply with a left-side mounted CMA ........................................... 8
2.2.
Replacing a power supply with a right-side mounted CMA ......................................... 8
Section 3: Cabling a PowerEdge R620 system on sliding rails without a CMA ............................. 10
3.1.
Routing the cables ....................................................................................... 10
3.2.
Removing the outer CMA brackets for shallow racks .............................................. 10
Section 4: Cabling a PowerEdge R620 system installed on static rails ..................................... 11
Figures
Figure 1.
System with cables installed ............................................................................. 4
Figure 2.
Routing power cables through the strain reliefs ...................................................... 5
Figure 3.
Attaching the inner CMA attachment bracket ........................................................ 5
Figure 4.
Routing the cables through the CMA .................................................................... 6
Figure 5.
Left-side mounted CMA installation (preferred) ...................................................... 7
Figure 6.
Right-side mounted CMA installation (CMA shown in service position) ........................... 7
Figure 7.
Disconnecting the CMA attachment housings ......................................................... 9
Figure 8.
Replacing the outer power supply ...................................................................... 9
Figure 9.
Cable routing without a CMA ........................................................................... 10
Figure 10.
Removing the outer CMA brackets for shallow racks .............................................. 10
Figure 11.
Cabling a system installed in static rails ............................................................. 11
