Dell Lifecycle Controller
Dell Lifecycle Controller (LC) provides advanced embedded system management capabilities including system deployment,
configuration, update, maintenance, and diagnosis. LC is delivered as part of the iDRAC out-of-band solution and Dell EMC
system embedded Unified Extensible Firmware Interface (UEFI) applications.
Related references
on page 64
Embedded systems management
The Dell Lifecycle Controller provides advanced embedded systems management throughout the lifecycle of the system. The
Dell Lifecycle Controller can be started during the boot sequence and can function independently of the operating system.
NOTE:
Certain platform configurations may not support the full set of features provided by the Dell Lifecycle Controller.
For more information about setting up the Dell Lifecycle Controller, configuring hardware and firmware, and deploying the
operating system, see the Dell Lifecycle Controller documentation at
Dell.com/idracmanuals
.
Related references
on page 64
Boot Manager
The
Boot Manager
screen enables you to select boot options and diagnostic utilities.
Related references
on page 65
on page 38
Related tasks
on page 64
Viewing Boot Manager
To enter
Boot Manager
:
Steps
1. Turn on, or restart your system.
2. Press F11 when you see the following message:
F11 = Boot Manager
If your operating system begins to load before you press F11, allow the system to complete the booting, and then restart your
system and try again.
Related references
on page 64
on page 65
64
Pre-operating system management applications
