I n f o r m a t i o n U p d a t e
1-1
This document provides updated or additional information for your system and addresses
the following topics:
•
Microprocessor
•
IDE drive configurations
•
Expansion card support
•
Ultra3 SCSI hard drive support
•
USB device support
•
System memory
•
Using the power button
•
Optical drive operation during operating system installation
•
Console redirection
•
Novell
®
NetWare
®
6.0
•
Red Hat Linux 8.0
Microprocessor
Your system supports the following microprocessors:
•
An Intel
®
Pentium
®
4 microprocessor with a 533-MHz front side bus speed, internal
processing speed of at least 2.4 GHz, and a 512-KB cache. Microprocessors with an
internal speed of 3.06 GHz or higher support Hyper-Threading.
•
An Intel Celeron
®
microprocessor with a 400-MHz front side bus speed, internal
processing speed of at least 1.8 GHz, and a 128-KB cache.
Installing the Microprocessor Heat Sink
The microprocessor heat sink includes thermal grease on the lower surface of the heat sink.
If you upgrade or replace your microprocessor, you must remove the protective cover on the
underside of the heat sink (see Figure 1-1) to expose the thermal grease prior to installing
the heat sink on the microprocessor. For more information on replacing the microprocessor,
see "Installing System Options" in the
Installation and Troubleshooting Guide
.
4Y169ebk0.book Page 1 Thursday, February 6, 2003 12:04 PM
