Dell PowerEdge 2900, Обновление информации, Страница: 13 / 190

Information Update
13
TPM configuration
operation honored.
System now resets. Information only.
TPM Failure
A Trusted Platform Module
(TPM) function has failed. See “Getting Help” in the
Hardware Owner’s Manual
.
TPM operation is
pending. Press I
to Ignore or M to
Modify to allow
this change and
reset the system.
WARNING: Modifying
could prevent
security.
Configuration change
has been requested. Press I to continue system
boot. Press M to modify the
TPM setting and restart.
Warning: Following
faulty DIMMs
are disabled:
DIMM n
1
n
2
Total memory size
is reduced.
Faulty or improperly
seated memory module(s).
DIMMs are disabled in
pairs, as indicated by the
n
1
and n
2
. Check both
DIMMs for a possible fault.
See “Troubleshooting
System Memory” in the
Hardware Owner’s Manual .
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
A fatal system error
occurred and caused the
system to restart. Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in See
“Troubleshooting Your
System” in the
Hardware
Owner’s Manual . for any
faulty components specified
in the SEL.
Warning! No micro
code update loaded
for processor n
Micro code update failed. Update the BIOS firmware.
See “Getting Help” in the
Hardware Owner’s Manual .
Table 1-1. System Messages (continued)
Message Causes Corrective Actions