Dell PowerEdge 1950, Руководство по установке

Страница: 30 / 202

28
Two-Post Rack Installation
• System rack kits are intended to be installed in a rack by trained service technicians. If you install the
kit in any other rack, be sure that the rack meets the specifications of a Dell rack.
CAUTION:
Do not move racks by yourself. Due to the height and weight of the rack, a minimum of two people
should accomplish this task.
• Always load the rack from the bottom up, and load the heaviest item in the rack first.
• Make sure that the rack is level and stable before extending a component from the rack.
• Use caution when pressing the component rail release latches and sliding a component into or out
of a rack; the slide rails can pinch your fingers.
• Do not overload the AC supply branch circuit that provides power to the rack. The total rack load
should not exceed 80 percent of the branch circuit rating.
• Ensure that proper airflow is provided to components in the rack.
• Do not step on or stand on any component when servicing other components in a rack.
Before You Begin
Before you begin installing your system in the rack, carefully read "Safety Instructions," found earlier in
this guide, as well as the safety instructions found in your
Product Information Guide for additional
information.
CAUTION:
When installing multiple systems in a rack, complete all of the procedures for the current system
before attempting to install the next system.
NOTE:
For instructions on installing the system itself, see ""Installing the System in the Rack" on page 37."
Important Safety Information
Observe the safety precautions in the following subsections when installing your system in the rack.
CAUTION:
You must strictly follow the procedures in this document to protect yourself as well as others who
may be involved. Your system may be very large and heavy and proper preparation and planning are important
to prevent injury to yourself and to others. This precaution becomes increasingly important when systems are
installed high up in the rack.
CAUTION:
Do not install rack kit components designed for another system. Use only the rack kit for your system.
Using the rack kit for another system may result in damage to the system and personal injury to yourself and to
others.
Recommended Tools and Supplies
• #2 Phillips screwdriver
• 3/8-inch wrench or nut driver (if changing bracket to flush-mount configuration)
• Masking tape or felt-tip pen to mark the mounting holes